English
Español
Deutsch
日本語
Polska
Français
中國
한국의
Українська
Nederlands
Türkçe
Português
Bahasa Indonesia
Русский
हिंदीdynamax bracelet sword and shield Modello di stampa 3D
- Formati disponibili: Stereolithography: stl 390.99 kb
- Collezione:No
- Stampa Pronta:No
- 3D Scan:No
- Per adulti:No
- PBR:No
- Visualizzazioni:5905
- Data: 2019-11-19
- ID Oggetto:263811
- Voto:
created this to compliment my sword and shield cosplay. this band is constructed in two pieces that slide into one another. this allows the bracelet to fit on your wrist without much difficulty.
it can be resized up and down pretty reliably. just make sure to scale both parts by the same increment.
the opening diameter measures 2.5 inches (63.5 mm) across.
the entire band measures approximately 82 mm x 82 mm x 66 mm. Stampa Pronta: No
Leggi ulterioriit can be resized up and down pretty reliably. just make sure to scale both parts by the same increment.
the opening diameter measures 2.5 inches (63.5 mm) across.
the entire band measures approximately 82 mm x 82 mm x 66 mm. Stampa Pronta: No
Hai bisogno di ulteriori formati?
Se hai bisogno di diversi formati, aprire un nuovo Ticket i Supporto e una richiesta per questo. Convertiamo modelli 3D a: .stl, .c4d, .obj, .fbx, .ma/.mb, .3ds, .3dm, .dxf/.dwg, .max. .blend, .skp, .glb. Non convertiamo scene 3d e formati come .step, .iges, .stp, .sldprt.!
Se hai bisogno di diversi formati, aprire un nuovo Ticket i Supporto e una richiesta per questo. Convertiamo modelli 3D a: .stl, .c4d, .obj, .fbx, .ma/.mb, .3ds, .3dm, .dxf/.dwg, .max. .blend, .skp, .glb. Non convertiamo scene 3d e formati come .step, .iges, .stp, .sldprt.!
Scaricato dynamax bracelet sword and shield Modello di stampa 3D stl Da httpkoopa
sword shield sword-and-shield bracelet accessory band dynamax cosplay cosplayer trainerNessun commento per quest'oggetto.
Oggetti relazionati Da dynamax bracelet sword and shield
-50%
stl
httpkoopa
Other
-50%
Printhub
Other
