Bonsai Pot rectangular 001 Modello di stampa 3D

Printable Rectangular bonsai pot design for bonsai lovers.
This design contains two models, one with only one drain mesh and other with two drain meshes. the legs are printed separately and for the legs you can select between two different heights.
More designs will come in the future.
You can print with default settings in your slicer. Pot and legs are designed separately to reduce support material waste. You can print the water tray and drain mesh only if needed.
I recommend 0.4mm nozzle for better quality. I have set support overhang angle to 60 degrees to reduce support materials. however you need to enable supports to print the leg cavities in the main body. for other parts you do not need supports. You will have to glue the legs to fix them to the pot after print. If your bed is not perfectly leveled you may need to remove some materials from the edges of the legs and leg cavities to fix the legs. If not you can print the "SMALL legs short" file which contains smaller leg design and fit loosely so it won't stuck. you can use PLA or PETG depending on the environment where you going to put your bonsai pot (recommend PETG if the bonsai pot gets direct sunlight) .
Dimensions
- length : 187mm
- width : 116mm
- height : 47mm (with legs attached)