ant man stl printing Modello di stampa 3D

ant man printing:
simplify3d settings:

this model was tested with pla material​.
to avoid printing problems, we recommend the following settings:
extruder
nozzle diameter: 0.4 mm
extrusion multiplier: 0.97
extrusion width: auto
retraction distance: 5.00 mm
extra restart distance: 0.00 mm
retraction vertical lift: 0.08 mm
retraction speed: 5400.0 mm/min
wipe distance: 5.00 mm
layer
primary layer height: 0.1 mm
top solid layers: 8
bottom solid layers: 5
outline/perimeter shells: 2
outline direction: inside-out
first layer height: 90%
first layer width: 100%
first layer speed: 20%
additions
use skirt/brim: check
skirt layers: 1
skirt offset from part: 6.00 mm
skirt outlines: 5
infill
internal fill pattern: fast honeycomb
external fill patern: rectilinear
interior fill percentage: 10%
outline overlap: 22%
infill extrusion width: 100%
minimum infill length: 5.00 mm
combine infill every: 1 layers
external infill angle offsets: 45/-45 deg
support
generate support material: check
support infill percentage: 15%
extra inflation distance: 1.00 mm
support base layers: 0
combine support every: 1 layers
dense support layers: 0
dense infill percentage: 70%
support type: normal
support pillar resolution: 5.00 mm
max overhang angle: 60 deg
horizontal offset from part: 0.50 mm
upper vertical separation layers: 1
lower vertical separation layers: 1
support infill angles: 45 deg
temperature
extruder 1 temperature: 210
heated bed: 60
cooling
increase fan speed for layers below: 45.0 sec
maximum cooling fan speed: 50%
bridging fan speed override: 100%
speeds
default printing speed: 4800.0 mm/min
outline underspeed: 50%
solid infill underspeed: 80%
support structure underspeed: 80%
x/y axis movement speed: 10800.0 mm/min
z axis movemen speed: 1002.0 mm/min
adjust printing speed for layers below: 15.0 sec
allow speed reduction down to: 20%
other
unsupported area threshold: 20.0 sq mm
extra inflation distance 0.00 mm
bridging extrusion multiplier: 100%
bridging speed multiplier: 100%
advanced
external thin wall type: perimeters only
internal thin wall type: allow gap fill
allowed perimeter overlap: 10%
minimum extrusion length: 1.00 mm
minimum printing width: 50%
maximum printing width: 200%
endpoint extension distance: 0.2 mm
only retract when crossing open spaces: check
minimum travel for retraction: 2.00 mm
perform retraction during wipe movement: check
only wipe extruder for outer-most perimeters: check
non-manifold segments: heal